Full Throttle Motorsports Pit Supplies

Front Wing Tool Tray - $57.50 Powdercoated ($50 uncoated)

This front wing tray is made to rest horizontal, with the wing at an inclined position. It features 16 holes,
on each side to hold nozzles and spark plugs. It also has a deep center pocket to hold tools, nuts, bolts, etc. so they are always right by you when you are working on the car.

Gear Oil Drain Pan - $42.50

This tray features an oil compartment that will hold the all the oil from any sprint or midget rear end. It also has a shelf that will allow the recently removed gears to drain of any excess oil before they are placed back in the storage compartment. The corner has a welded pouring guard in that keeps the oil pouring out at a constant rate so you get a smooth pour into the proper oil disposal receptacle.

Torsion Bar Tray - $40.00

This pit tool hangs right on the torsion tubes on the car, and hold 2 torsion bars. Works great in the shop when taking the bars out to clean them and grease them. Also features a pocket to hold the stops and arms when they are off the car, keeping them off the ground or getting lost.

Engine Puller - $60.00

This device uses a laser cut steel center section, with one high-strength strap on each end. The steel center section gives a more positive hoist location, to keep the motor level while removing or installing. It will not slip to one end or the other, like the all strap engines pullers do. The angled ends on the straps allow the straps to be pulled tight against the engine, but will clear anything on the engine. Scroll over image to see a close up of the ends.

Aluminum Tool Caddy - $94.75

- Picture Coming Soon -

This Tool Caddy is perfect to hold all the tools and small parts needed to perform an emergency repair under a red flag. Long enough to hold from and rear arms, and will carry about anything needed.

Back to New Products Home Page